I have an issue with hardwiring. I went to a shop to get it done. These guys are pretty good but for some reason we cannot get it right.
1) They did the first hardwire install. Everything is great camera is on while driving and on while engine is off... But then I notice that it is recording in full quality and frame rate while parked, even though I put parking mode into 5 FPS. So my conclusion was: they messed up the wiring somehow. The camera does not sense the switch from ignition on to ignition off. So I went back to them today...
2) Explained again where yellow and red wires are supposed to go. They said they did everything according to the instructions but will swap the red and yellow wires. They did say that they are hooking it up to the ignition, they way they hook up remote start systems. After they swapped the wires camera is working while car is running... but turns off completely once ignition is off.
I went back to them and they said they are not sure what the issue is but they can switch it back to (1). I don't really want that for two reasons: running while parked at full frame rate will fill up the card fast and may drain battery quicker.
Any thoughts on what the issue is? Wrong install? Bad hardware?
1) They did the first hardwire install. Everything is great camera is on while driving and on while engine is off... But then I notice that it is recording in full quality and frame rate while parked, even though I put parking mode into 5 FPS. So my conclusion was: they messed up the wiring somehow. The camera does not sense the switch from ignition on to ignition off. So I went back to them today...
2) Explained again where yellow and red wires are supposed to go. They said they did everything according to the instructions but will swap the red and yellow wires. They did say that they are hooking it up to the ignition, they way they hook up remote start systems. After they swapped the wires camera is working while car is running... but turns off completely once ignition is off.
I went back to them and they said they are not sure what the issue is but they can switch it back to (1). I don't really want that for two reasons: running while parked at full frame rate will fill up the card fast and may drain battery quicker.
Any thoughts on what the issue is? Wrong install? Bad hardware?