Because I believe that Thinkware should include this option. We're on a forum, a forum for discussion.
Maybe someone from @Thinkware Dash Cam might think this is a great idea and implement it into future firmware if they feel is the right thing to do.
How about instead of jumping on your high...
I have no answers to the above, but I've just setup a Blackvue DR900S in my other car.
One thing I do like is you can select the detection zone. This reduces the chances of false detection and depending on how far away that tree (= how tall it is). It may fall outside this detection zone.
I'm not understanding and maybe I'm reading too much into this.
I'm trying to work out the benefits of having a Battery Pack like the Cellink Neo.
I know they will prolong the life of the car battery because it's not draining the battery down.
But I've read some people say, you get...
Ah so that's how that works, good to know.
Nope not deliberate at all, I've turned it down to the lowest setting so lets see how that goes. Worse case scenario I'll switch it off.
The result of driving a stiff suspension go kart :LOL:
Connected the U1000 up on Saturday, went for a drive. Looking at the footage and file sizes I have a few questions.
I've noticed that 1min it uses roughly 200MB Front and 100MB Rear.
However, when there is an event (G Sensor is triggered) and it switches over to an Event File the...
I've had one of these cameras hanging off my windscreen for a little while now but I think the capacitor is dead.
The reason why I say this is the moment the power gets cut to the dash cam it would instantly switch off.
If I recall correctly it use to take a second or two before it's a...
I was just hoping on here to ask about the same situation
I have mine to power on and auto record and also immediate disconnected when off and it's only working sometimes
The issue is when the camera starts recording it takes a few seconds to power off and when you crank the engine over the...
I was going to try erase but that didn't work something about it not being supported so I went with overwrite which took a lot longer than quick did
It seemed to work fine on day one but after day two (only filled up 1/3rd of the card) it came up with card error again so perhaps this card is...
Last night I looked around at fake SD cards to see perhaps mine is a fake and I came across a program called H2testw and I ran that over night and this was the results
I'll try that program you linked me to in a moment and see how it goes