Search results

Thanks jokiin and OCD. The lens is working in focus now. Perhaps I hadn't tightened the lens locking ring enough before. Also one needs to ensure (I think), that the 4 notches in the insert engage with the 4 corners of the square lens base. Another thing to watch out for is to ensure, when...

Many thanks for both responses and apologies for my tardy acknowledgement. When I said ¨lens¨, kamkart1, I meant the same as Innovv did when they sold it i.e. the lens with cable attached but the link you gave is interesting and I've saved it for later. What made me believe some damage had...

Does anyone have any idea where I might obtain a new/secondhand lens (any FOV) for my C3? I've had two of them since 2014 but one lens got damaged somehow whilst in storage for a while. Both units still work fine and it would be a shame if I can't find one. Thanks for reading. Bill

If Spanish is still required, I'll do it (Castilian, South American Spanish has differences), no charge. To be accurate, the words alone wouldn't be sufficient. The context needs to be made clear. j1m-fred@talktalk.net

Well Done, Rock: the March firmware seems to have resolved my file naming and sound issues. However, on a cold (2°C) night last week, the car failed to start first time and I forgot to wait ten or fifteen seconds before trying again, with the result that the only file recorded was the second or...

Street Guardian's point about a startup delay is a valid one to avoid possible malfunction over a period of time, but this is not the issue in my case as I demonstrated in my post Tuseday when I used a powerbank instead of the car's battery. I have also tried connecting the power cable to the C3...

I had this occur ten days ago when the temp. was around 0°C and the engine didn't start on first try. Turned the key again and it started. As in your case, nothing was recorded on that trip. This non-starting on first try happened again the following morning but on the second try, I noticed that...

I've just done the same trip again with FWC.bin 10/12/14, same config, Loop on, radio on but disconnected from the car and instead connected to a power bank by the short cable (the manual ¨calls it ¨USB cable¨ under Accessories). Switching on and off the car was simulated by plugging in and...

I forgot to state that my C3 is the capacitor model with wide angle lens. Here's a third trip the same as before with firmware FWC3.bin 1/9/14, same config, switch set to Loop, radio on. The HT files are unreadable, like before. Trip begins with L0000001.MOV and is sequential to L0000007.MOV...

Here's another set of clips of the same trip using firmware FWC3.bin 15/9/14, same config file, switch set to Loop. HT000001.MOV is unreadable and was probably created when I flashed the September firmware. The trip begins with L0000002.MOV and continues sequentially to L0000006.MOV when I stop...

Here are the clips from a short trip just completed. Firmware FWC3.bin 10/12/14. Config file renamed just for uploading. Switch set to Loop Mode. Files L000001.MOV to L000005.MOV are recordings prior to the trip when I was adjusting the position of the C3. The trip begins with HT000006.MOV with...

Thanks for putting me straight cf7 and parklawn. My Noscript add-on to Firefox was preventing ¨The C3 downloadable FW, GUI, Video clips¨ from appearing. Camera re-jigged but as it's -1° now (I know, I know, that's sunbathing weather for you blokes) and the car is frosted over, I'll wait until...

Thanks cf7. After I'd posted I checked out http://www.minidvcameras.co.uk from where I bought my camera and there's a link, http://bit.ly/1kMFtcv, to 2kool4u.com where I grabbed firmware FW26.bin dated March 13 2014. I'll give that a go tomorrow as it's taters out and it's near dinner time...

First off, Happy New Year all! Same ¨problem¨ here. I got my C3 for Xmas and finally settled on a mounting position and hardwired it in. I updated the firmware per Rock's post on Dec 11 to FWC3_20141210, wrote a config file and set the switch to loop mode. See attached screenshot as an example...

Zendure state their A series is capable of passthrough charging. Here's what the A2 (6000 mAh) manual states: Charge-through Function In charge-through mode, the total maximum input is 2A. Depending on the output current that's been drawn, Zendure will be charged at what's left. For instance...

Hoping my C3 arrives next week and planning a hardwire installation. As I didn't pay enough attention in physics lessons at school, I'd would like to know what rating fuse to use.

Just ordered wide angle version and real price is £96.99 including 20%vat.

Nice picture? Are you coming down the chimney?:D

Hello all. Christmas is coming and I really, really want the capacitor model to be in a gift-wrapped box with my name on it under the tree on Christmas Day. Any news on the likely release date RockThinking?