My A800 with rear cam running FW 1.0.6ww is not able to get any GPS data, and ADAS is not working despite successfully calibrated(voice prompt and indicator on screen shows a tick on ADAS icon). I've connected my unit using hardwire kit, My A800 unit will power up normally when i start my engine and my will prompt "entering parking mode after 5 minute" after i off my engine, so i assumed the hardwire kit is working as expected. I enabled GPS/ADAS/Parking surveillance in the settings, and also checked via app that these are indeed enabled.
Video recording is working as expected, however the speed and GPS location will just show -- -- -- -- in all the footage.
I did not get any ADAS warning at all throughout my 1 hour drive, regardless of what i do.
Parking surveillance is also not working, i tried to manually simulate impact after the camera entered parking mode, the indicator light up RED for few seconds, then died completely.
After i restart the car and check the camera, there is no parking mode footage at all.
I've checked the GPSData000001.txt in my microSD and it is completely blank.
Have tried doing factory reset, format card and both are still not working.
Been driving for 2-3 hours after i had the camera installed.
Is my unit faulty? anyone else encountered this?
Video recording is working as expected, however the speed and GPS location will just show -- -- -- -- in all the footage.
I did not get any ADAS warning at all throughout my 1 hour drive, regardless of what i do.
Parking surveillance is also not working, i tried to manually simulate impact after the camera entered parking mode, the indicator light up RED for few seconds, then died completely.
After i restart the car and check the camera, there is no parking mode footage at all.
I've checked the GPSData000001.txt in my microSD and it is completely blank.
Have tried doing factory reset, format card and both are still not working.
Been driving for 2-3 hours after i had the camera installed.
Is my unit faulty? anyone else encountered this?