Hi all, ive installed a viofo a129 (updated firmware as well) and connected it to cellink neo6.
When i park and leave my car im aware that my dashcam is running obviously because its connected to the cellink but i dont think its in buffered parking mode? When the car is off and i check the screen i just get the logo of a car and a person running beside of it (indicating motion detection?)
Ive set all the settings according to the viofo website for buffered parking mode: Auto event detection, high parking g sensor sensitivity, low motion detection and it does record a few instances of motion detection but also surely when i get into the car the movement of me closing my door should enable g sensor activity and start recording like that right?
Does anyone have any advice/settings that would allow me to get it into parking mode? Or maybe ive wired it wrong in my car, but ive connected all the cables correctly.
When i park and leave my car im aware that my dashcam is running obviously because its connected to the cellink but i dont think its in buffered parking mode? When the car is off and i check the screen i just get the logo of a car and a person running beside of it (indicating motion detection?)
Ive set all the settings according to the viofo website for buffered parking mode: Auto event detection, high parking g sensor sensitivity, low motion detection and it does record a few instances of motion detection but also surely when i get into the car the movement of me closing my door should enable g sensor activity and start recording like that right?
Does anyone have any advice/settings that would allow me to get it into parking mode? Or maybe ive wired it wrong in my car, but ive connected all the cables correctly.