Hello again,finally I have connected the Neo battery to the fuse panel and everything works perfectly fine as I wanted to be. Anyway,I have noticed a strange thing: connecting to a 10A fuse which is the only one live with the ignition on and dead with ignition off, I have noticed that the Neo battery is NOT charging with the ignition on only, it starts to beep and charge only with the engine running,which is the way that I needed to be .. So I said to myself: what a good thing,the Neo battery have a voltage protection and only charges when the alternator is running(14,7V) and not charging when alternator is off(12,8V from car battery only). Then for safety reasons I have changed the Neo to a 20A fuse (lighter sockets) which is live 10 -15min after locking the car(thinking the Neo have this voltage protection). For my surprise on this fuse the Neo battery beeps and starts to charge immediately with the ignition off and the engine off (not good at all for the car battery because of the 15min delay). I have reconnected to the initial 10A fuse again and this time again the Neo beeps and starts charging immediately with only the ignition on,without starting the engine..So strange it behaves differently now,as a few minutes ago was ok and not charging if the ignition was on(12.8V live from car battery) and engine off with this 10A fuse...So I have to let it connected here because this fuse only gets power with ignition and engine on,and is the only one in the fuse box live only when ignition and engine are on....I let the charge selector on the Neo battery at 5A because 9A is too much for this 10A fuse circuit.Anyway I do a 16-18min trip in the morning to my job and 16-18min back home,and every morning when I arrive to my job garage the Neo is 100% charged on 5A option.My A129 Pro Duo is recording in low bitrate parking mode for 9 hours while car is parked at my office garage,and I power it off when I arrive home because I don't need it in my home garage.The dashcam is switching on 4K+FHD when I start the engine,and when I stop the engine is switching perfectly fine to FHD-FHD low bitrate parking mode,I'm so happy is not failing anymore with the parking/driving mode switch..I've used the 3 wires HK to connect the camera to the Neo battery,maybe this is the reason is working fine now.