eggman89
New Member
Hi all
My current set up is as follows :
Car cigarette output - > Celllink Neo
Celllink Neo Ciggerate output-> Viofo A129 Plus Duo
Parking mode : Auto detect event
Parking G sensor : Med
Parking Motion Sensor : Med
G Sensor : Off
Motion Sensor : Off
Here's the behavior :
1. Once in driving mode, if the car doesn't detect any action for few (maybe 5) minutes it goes into parking mode.
2. once in parking mode, it works as expected.
Buffer records if the car has been hit.
Here's the problem
3. Once I start driving, the cam never gets out of the parking mode. It's always stuck in the event mode. From my understanding is, once the GPS hits 8mile/h, the car should switch to driving mode.
However this isn't happening.
On further testing, the switch back from Parking to Driving mode isn't happening on any of the parking modes.
How do I trigger the cam to automatically go back to driving mode.
If hardwiring is indeed the solution, I can only hardwire the camera to Battery. But absolutely can not hardwire anything to the car.
Is it possible to hardwire Cellink Neo to Viofo.
I have the Cellink output unspliced cable and Viofo Harwiring kit.
They both have Red, Black, yellow cables. But how do I connect them?
My current set up is as follows :
Car cigarette output - > Celllink Neo
Celllink Neo Ciggerate output-> Viofo A129 Plus Duo
Parking mode : Auto detect event
Parking G sensor : Med
Parking Motion Sensor : Med
G Sensor : Off
Motion Sensor : Off
Here's the behavior :
1. Once in driving mode, if the car doesn't detect any action for few (maybe 5) minutes it goes into parking mode.
2. once in parking mode, it works as expected.
Buffer records if the car has been hit.
Here's the problem
3. Once I start driving, the cam never gets out of the parking mode. It's always stuck in the event mode. From my understanding is, once the GPS hits 8mile/h, the car should switch to driving mode.
However this isn't happening.
On further testing, the switch back from Parking to Driving mode isn't happening on any of the parking modes.
How do I trigger the cam to automatically go back to driving mode.
If hardwiring is indeed the solution, I can only hardwire the camera to Battery. But absolutely can not hardwire anything to the car.
Is it possible to hardwire Cellink Neo to Viofo.
I have the Cellink output unspliced cable and Viofo Harwiring kit.
They both have Red, Black, yellow cables. But how do I connect them?