Fuse tap that doesn't overlap other fuses?

PB97

New Member
Joined
Mar 21, 2025
Messages
7
Reaction score
4
Location
Greenwich, London
Country
United Kingdom
Dash Cam
Garmin
I need to install a couple of fuse taps into an already crowded fuse box (I have a disability hoist installed), which is causing me some issues.

The main one is that the fuse taps overlap the fuses in the next slot, meaning that I can't tap those fuses, so I'm either going to need to take power some other way or to tap fuses that I've been advised against tapping.

Does anyone make a fuse tap where the fuses are vertical rather than horizontal?

I need to be able to tap two fuses that are next to each other.
 
you could do the ghetto way tapping into a fuses leg with a wire ( wrapping wire around original fuse leg ), but then you of course will need a inline fuse on that wire to fuse what you are adding.
I can not recall different design fuse adapters that do not lean in over the fuse next to it,,,,, TBH a bit funny that do not exist, it would be advantageous to have at least 2 different " lean " directions available
 
That looks like something that my insurance company would advise against.
 
Something akin to that do seem to exist.

That is a functional answer, but make sure you put it the correct way around, otherwise the camera doesn't have any fuse protection.

That looks like something that my insurance company would advise against.
It is better than what some professional installers do!

Normally, if you want to tap fuses next to each other, you can put the two fuse taps opposite ways around.

Also, fuse taps can be shared, so normally you will only actually need two fuse taps, one for permanent and one for switched. If you share a fuse tap, you might want to add additional inline fuses, but they don't need to be in the fuse box,.
 
Yes i forgot that you can flip the tap so the added circuit wire come off to opposite sides and the 2 fuses would lean to the left / right over any fuses there.

But yes have to be mindful of that thing i found, there is a in and a out side in a fuse box, so with that think you can have 0 fuse on the added circuit, or be covered by the fuse itself.
Personally i would prefer to set it up with 0 fuse and then add a inline one on the new circuit wire, the fuse you tap into is probably also a larger one 7 - 10 -15 - 20 -30 A but i would prefer a 5 A fuse for the dashcam side.
Maybe even smaller than 5 A if need be, i have run several systems on a 5 A fuse with up to 9 cameras in total, so 5 A is plenty

That thing it would be cool if it was fitted with a 1 way circuitry, that way it would only work in the " correct " orientation, which could be covered by existing fuse or add a fuse to your new circuit.
 
but they don't need to be in the fuse box,.
Indeed, the multi port USB chargers i have run for a decade or so, housed in my glove box, they are tapped into the wires that go to the 12 V socket on the dashboard CUZ that day i did not feel like going for the fuse box which in my car is in a unfortunate place for a age plagued no longer that flexible guy.
 
What car make ?

Honda have a dedicated slot
 
can I safely use on of these to get a piggyback fuse tap into a tight space?

£1.16 | 32V ACC Large Size Standard Mini Micro2 Size Car Fuse Holder 16AWG Non-Destructive Fuse Box ATM Blade Fuse Extension Cord

I'd put the tap in where the fuse would go?
 
Back
Top