Hardwiring for Honda Pilot and CR-V

[XR2424]

Hi folks,
I just finished hardwiring my 2019 Honda Pilot and 2011 CR-V.
The only consistent and reliable always-hot fuse I found was the door locks fuse (I didn’t want to tap any safety related systems). Everything looks to be working fine.
Is there any issue tapping to the door locks fuse?

Thanks for any input.
CK

 

[wozzzzza]

if there isn't an accessories easy to access and as long as it constant power then no probs i can see.

 

[XR2424]

I looked at the wiring diagram in the service manual and the door locks are controlled by the MICU which may cause issue with the B-CAN and cause power shutdown if unexpected load is registered. So ended up with the accessory socket fuse for the always on (turns out it is negative switched/relay), and the rear passenger power window fuse for the switched (I was surprised it wasn’t always on).
So all good now and camera goes in and out of parking mode as it should.