Hello everyone, I had the mini 0906 installed at a shop with the hardwire kit, how can I tell if parking mode is working how it should? I saw in the updated firmware manual theres a red "P" with a circle around it for parking more, however when I turn the car off I never see that, I only see a grayed out one when I have parking mode set to auto switch timelapse. I tried all different settings in the parking mode menu and when sitting in the car after turning it off, with power off delay set to off, the frame rate stays at 1080 and never changes. The cutoff voltage is set to 12.2, I have seen some in here also mention that there is an option in the parking guard menu to turn it off, but I don't see that option. I set screen off delay to 15 seconds because when that was set to "off" the screen always stayed on. I have been manually turning the camera off when I park so it wont overheat because I am unsure if it is actually going into standby mode and in the parking guard setting. Thank You. By the way, the hardwired kit I got, I got off of amazon its the veckle hardwire kit.