Mobius mounting holder

Tony lovelock

Active Member
Joined
Jan 18, 2017
Messages
612
Reaction score
133
Location
Hampshire
Country
United Kingdom
Dash Cam
Nextbase 422gw/Nextbase 212G & möbius C3 wide angle lens
what is the correct thread name for the möbius mounting holder plastic centre lug? I know it's 1/4" but will a unc/whitworth threaded bolt screw into this? It's the small black plastic centre piece that will screw in the many tripod adapters. Thanks
 
That and all standard tripod threads are nominally 1/4 inch diameter with 20 threads per inch, usually referred to as "1/4-20" or "1/4 UNC". This is an American thread size but is a worldwide standard. There are other tripod mounting thread sizes but they are uncommon. Look for either the 1/4-20 designation or the word "standard" ;)

Phil
 
the thread size is standard, I have found the fitting on the Mobius is quite short though and I have a few different mounts that bottom out before becoming tight which necessitates having to add some washers or whatever to space it out a bit or you can't lock it down
 
Thanks, will look on eBay for a countersunk version then!
 
Back
Top