Park Mode

[Tman]

After scrolling through this forum, i remain a bit confused. I now understand that the yellow cable on the hardwired kit is useless and should not be connected to anything for B1W.
I also understand firmware 20180614s should be uploaded to the B1W.

Is there a clear guide on sequence or procedures that needs to be followed in order to activate Park mode when i arrive at a destination? i ask these questions as i have tried the double press with no luck. What are the uses of wifi on and wifi off firmwires and modes.

thanks to all.

 

[estore009]

Red wire to the 12V always-on socket, Black wire to GND; Yellow wire Unconnected;

1, If the camera detects no move on G-sensor within 3 minutes, the parking mode is activated.
2, When the G sensor starts being triggered during parking mode, it switches to the normal recording.

 

[Tman]

Thanks estore009.

so i have added firmware 20180614s to my dashcam, do i need to add any more firmwires? do i need the wifi on wifi off firmwire?

 

[estore009]

do i need to add any more firmwires? do i need the wifi on wifi off firmwire?

Nope!

 

[Tman]

Nope!

Thank you so much. you have been very helpful. i have will move the red wire from 12V switched to 12V constant