Parking Mode problems

Discussion in 'DR750LW-2CH' started by Terry Geove, Jan 21, 2017.

  1. Terry Geove

    Terry Geove New Member

    Messages:
    2
    Likes Received:
    0
    Country:
    Canada
    I recently purchased a Black Vue DR750. It worked well until I didn't use my vehicle for 3 days and my cars battery was drained. I then had a Power Magic Pro installed. Now the parking mode will not activate at all. The camera settings for power cut off is 12.3V/36hrs. Do the camera settings have to match the ones on the PMP?Does anyone have any ideas.
     
  2. JohnM

    JohnM Active Member

    Messages:
    187
    Likes Received:
    31
    Location:
    Lincs
    Country:
    United Kingdom
    Dash Cam:
    DR650GW-2CH
    Hi Terry

    Check your battery, perhaps it's below 12.3V. More likely your PMP has been fitted incorrectly (both leads connected to switched ignition fuses), or it's not switched on, or it doesn't work.

    Good luck

    John
     
  3. Hillbilly

    Hillbilly Well-Known Member

    Messages:
    1,548
    Likes Received:
    220
    Country:
    Australia
    Is the switch on the PMP turned on
     
  4. Terry Geove

    Terry Geove New Member

    Messages:
    2
    Likes Received:
    0
    Country:
    Canada
    My problem is solved. The PMP was faulty. I had it replaced and the camera works as advertised.
     

Share This Page