Re-connecting?

Flip_Flop

New Member
Joined
Jul 18, 2022
Messages
12
Reaction score
1
Location
Somerset
Country
United Kingdom
There is an option to buy a DR900S but the wires have been cut, presumably because they were imbedded in the vehicle so that the only way to get them out was to cut and then pull from each end.
So the question is given one has the soldering equipment, which I have, how easy is to to re-connect the wires please?
Thanks in advance for any helpful comments or suggestions.
Nigel
 
As I recall on my wiring kit there were no terminals, just a short segment of bare wire back a cm or so from the end. I think the intent is to solder to.. whatever. In my case the bit of wire/lead that comes a add-a-fuse thingmie. But, if you were connecting to a power pack that needed proper terminals one would have to purchase the appropriate male bits and solder them to your wires.
Good Luck
 
Thanks, Ralph2. Noted and much appreciated. An electical engineer I know suggests there would be video signal wire, possibly braided and up to three others - at least two for power, so it should not be a problem re-connecting them. Thanks again.
 
Back
Top