D
Deleted member 56879
Guest
Parking Mode is set to “motion” with the lowest setting of sensitivity, which should mean that very little should trigger it to record, yet when my car is in my garage it seems to be always recording in Parking mode.
So much so, that it fills the entire 32gib SD.
Yesterday we went for a 4 hour drive and continuous mode captured only the last 45 minutes of the entire day.
The wiring is correct, confirmed by BBMC and I can here it switching modes when I start the car and stop the car.
I switched the parking mode to incident only (non buffered) to see if this makes a difference.
I will admit that my garage door had windows, and despite the windows being covered in a shoddy way, there may be some lights outside causing slight motion. I also back this car in, so it’s always facing the garage door.
How sensitive is the motion supposed to be? I set it as as it can go....
Sent from my iPhone using Tapatalk
So much so, that it fills the entire 32gib SD.
Yesterday we went for a 4 hour drive and continuous mode captured only the last 45 minutes of the entire day.
The wiring is correct, confirmed by BBMC and I can here it switching modes when I start the car and stop the car.
I switched the parking mode to incident only (non buffered) to see if this makes a difference.
I will admit that my garage door had windows, and despite the windows being covered in a shoddy way, there may be some lights outside causing slight motion. I also back this car in, so it’s always facing the garage door.
How sensitive is the motion supposed to be? I set it as as it can go....
Sent from my iPhone using Tapatalk