Restore default settings

szenteb

New Member
Joined
May 3, 2019
Messages
19
Reaction score
11
Country
Hungary
Hello,

After the latest firmware update my cam does not work. Screen always on and I can not use any of buttons. Only I press on/off button for 15 sec to off the screen.

Can anyone support me how can I restore default settings / reset my cam?

Thank you in advance.

Regards,
Balázs
 
Thanks, but my cam's buttons did not work the whole cam was freeze.
I still reset my cam with the following steps:
1. I downloaded an earlier firmware version (e.g.: 1.0.5 or 1.0.7)
2. After it I copied the unzipped update library (with contents) to the sd card's root library
3. After that I put back the sd card to the cam and I pressed the power on / off button and the right button at the same time for a few seconds
4. I followed the instructions
 
Good to know there's a way to fix the problem (y)

I always advise to never upgrade anything until you see what others experience with it because sometimes "upgrades" cause more problems than they solve :cautious:

Phil
 
고마워,하지만 내 캠의 버튼이 작동하지 않았는데 캠 전체가 멈췄다.
여전히 다음 단계에 따라 캠을 재설정합니다.
1. 이전 펌웨어 버전 (예 : 1.0.5 또는 1.0.7)을 다운로드했습니다.
2. 압축을 푼 업데이트 라이브러리 (내용 포함)를 sd 카드의 루트 라이브러리에 복사했습니다.
3. 그 후 sd 카드를 캠에 다시 넣고 전원 켜기 / 끄기 버튼과 오른쪽 버튼을 동시에 몇 초 동안 눌렀습니다.
4. 나는 지시를 따랐다
고마워,하지만 내 캠의 버튼이 작동하지 않았는데 캠 전체가 멈췄다.
여전히 다음 단계에 따라 캠을 재설정합니다.
1. 이전 펌웨어 버전 (예 : 1.0.5 또는 1.0.7)을 다운로드했습니다.
2. 압축을 푼 업데이트 라이브러리 (내용 포함)를 sd 카드의 루트 라이브러리에 복사했습니다.
3. 그 후 sd 카드를 캠에 다시 넣고 전원 켜기 / 끄기 버튼과 오른쪽 버튼을 동시에 몇 초 동안 눌렀습니다.
4. 나는 지시를 따랐다
이것은 문제를 해결 했습니까 ???
어때요?
 
Back
Top