I'm not having much luck with dashcams so far. After trying the G1W-CB & the A118C I decided to just spend the money and get the SG9665GC.
First - when I unplugged the usb cable, the usb cable plug-end actually separated when I removed it. So the metal casing of the plug is stuck in the camera. I was able to push the plastic end back in, and it works but... not sure what to do about that. I was planning on hard-wiring the camera so I'm going to need to get that casing out.
Secondly - my video looks blurry. This doesn't seem normal. I do have the polarizing lens on the camera. I've lost daylight so I can't try again without it until tomorrow.
What am I doing wrong?
Here's my short video around the block (hopefully I link this right the first time):
https://www.dropbox.com/s/wj6q7ai5t...163409_005 (4-34-40 PM - 4-37-08 PM).MOV?dl=0
I did clip the video using the registrator software because I walked around the front of the car and studied the placement for a while, looking like a doofus.
First - when I unplugged the usb cable, the usb cable plug-end actually separated when I removed it. So the metal casing of the plug is stuck in the camera. I was able to push the plastic end back in, and it works but... not sure what to do about that. I was planning on hard-wiring the camera so I'm going to need to get that casing out.
Secondly - my video looks blurry. This doesn't seem normal. I do have the polarizing lens on the camera. I've lost daylight so I can't try again without it until tomorrow.
What am I doing wrong?
Here's my short video around the block (hopefully I link this right the first time):
https://www.dropbox.com/s/wj6q7ai5t...163409_005 (4-34-40 PM - 4-37-08 PM).MOV?dl=0
I did clip the video using the registrator software because I walked around the front of the car and studied the placement for a while, looking like a doofus.