newcamman
New Member
- Joined
- Dec 29, 2019
- Messages
- 26
- Reaction score
- 17
- Location
- Indiana
- Country
- United States
- Dash Cam
- SG9663DCPRO
I just installed my hardwire kit for the DCPRO (old rear camera) running firmware version 1.17. I just can't seem to get the camera to enter into parking mode. I have it set to 3 wire, 30FPS with a shutdown time of 6 hours, and sounds turned on.
I hear no sound when I shut the car off, and I don't see the icon that the hardwire kit manual mentions when the camera enters parking mode. The camera just appears to stay in the normal driving mode. I'm fairly certain I have a good accessory connection since it my 12V sockets switch when expected, and the relay for this circuit shares the same coil power source as them. (See attached.)
See attached for the circuit diagrams for the circuits I'm using.
Car: 2016 Nissan Altima with
Batt: 14
ACC: 25
I hear no sound when I shut the car off, and I don't see the icon that the hardwire kit manual mentions when the camera enters parking mode. The camera just appears to stay in the normal driving mode. I'm fairly certain I have a good accessory connection since it my 12V sockets switch when expected, and the relay for this circuit shares the same coil power source as them. (See attached.)
See attached for the circuit diagrams for the circuits I'm using.
Car: 2016 Nissan Altima with
Batt: 14
ACC: 25