Nixxx
New Member
Hi all, just bought an A139 2ch direct from Viofo UK. I have installed it in my MX5 using the supplied cigarette lighter power socket. I am also using the Viofo supplied 256 GB SD card. I had no strange issues installing - it was very straight forward. I’ve installed 3 different dash cams in the past so this isn’t something new to me.
I’ve been having problems since day one with this camera. It constantly beeps as if it’s lost power or is power cycling. It will say “recording one channel started” even though I have two channels. It will beep, then reboot and say “recording two channel started”. This will last for a little while and then it will just start beeping non stop. It’s quite frustrating. Seems to happen when I’m driving on rough surfaces.
I’ve updated the firmware to the latest on the site (I think it’s 1.5) Any suggestions?
I’ve been having problems since day one with this camera. It constantly beeps as if it’s lost power or is power cycling. It will say “recording one channel started” even though I have two channels. It will beep, then reboot and say “recording two channel started”. This will last for a little while and then it will just start beeping non stop. It’s quite frustrating. Seems to happen when I’m driving on rough surfaces.
I’ve updated the firmware to the latest on the site (I think it’s 1.5) Any suggestions?