Wire kit for B1W

abubin

Member
Joined
Jan 31, 2019
Messages
46
Reaction score
9
Country
Singapore
I just got B1W.

Looking to get the hard wire kit. Not sure whether to get the 2-wire or 3-wire kit. As I know the ACC wire is not used. So 2-wire kit should be sufficient, right? However some says the ACC wire might be used in the future.
FYI, the 3wire kit is double the price of 2 wire kit. I just don't want to waste money if the wire is not needed.

Is this 3-wire kit good enough?
 
Last edited:
While there is no information whether the transition to the parking mode will be implemented as it was done by the control signal of the mini 0906, it is unlikely that the B1W will go in this direction, the development was carried out in the direction of using the G-sensor.
Therefore, it is enough to use a 2-wire adapter.
This 3-wire kit adapter for mini 0906 works well, for use in B1W connect the yellow and red wires together and connect them to the ACC line
 
Back
Top