Hello, I am fairly new to the forum, but I had a question about the motion setting on the wr1. I currently have a Magellan MiVue 480D dual channel camera in my car, but it's a battery model cam and I'm not sure how long it's going to last here in south Texas heat. So, I wanted to switch to a capacitor rear camera and I have a wr1 laying around that I figured I can use. I ordered an Opia2 that should be in sometime next week that will be my dedicated front facing camera. I reached out to Vico with the same question for the Opia2.
My question is, I have two power outlets in my car. One is located in plain sight and is only powered on when the car is running. The second power outlet is hidden in the center console, but easily accessible. Can I set the motion detection on since constant power will be supplied to the wr1? When can I tell the wr1 has gone into standby if no motion is detected? I hooked the wr1 to a battery pack in my house and set the motion detection on. It seems as if the camera stops recording after about 5-7 minutes if there isn't any motion to be detected. The red led light flashes rapidly and the green led light continues to flash at a normal rate, but when motion is detected the red led light turns solid and the green led continues to flash at a normal rate. When the red led light flashes rapidly does that mean the wr1 is in standby mode?
I apologize for the length of this post.
Thanks in advance for any help.
My question is, I have two power outlets in my car. One is located in plain sight and is only powered on when the car is running. The second power outlet is hidden in the center console, but easily accessible. Can I set the motion detection on since constant power will be supplied to the wr1? When can I tell the wr1 has gone into standby if no motion is detected? I hooked the wr1 to a battery pack in my house and set the motion detection on. It seems as if the camera stops recording after about 5-7 minutes if there isn't any motion to be detected. The red led light flashes rapidly and the green led light continues to flash at a normal rate, but when motion is detected the red led light turns solid and the green led continues to flash at a normal rate. When the red led light flashes rapidly does that mean the wr1 is in standby mode?
I apologize for the length of this post.
Thanks in advance for any help.