I reinstalled my Nextbase 402G after a recent near accident I wish I had captured, so after two years without use the battery was no longer taking charge and the camera would just immediately turn off when the car ignition was turned off (hardwire kit). So I gt a replacement battery and gave it a good charge and updated the firmware (R09) whilst I was getting it ready to be used again, but now I have a new problem, it seems the camera will cut off like before but immediately turn back on again and stay on (as in the screen) until the battery runs out and the 'Low Battery' message displays and it beeps. Any idea what is going on with this? Is it the firmware? Is it somehow the new battery despite it charging and holding charge?