takigama
New Member
Hi All,
I've seen a few posts about people having the same issue, so I'm assuming the cam is dead. But it boots up, never says "recording, 2 channels started" then a couple of second later I hear the boot sound again (repeat forever).
I'm using the viofo hardwire kit for this particular cam and its about 8 months old.
What i've tried so far:
1) eject the card (boots and says "please insert memory card, please insert", yes it stops mid sentence, but doesn't reboot again)
2) reset (both yellow and wifi button which causes a beep, and the reset in the recessed hole), neither works
3) new card - no difference
4) tried the USB power supply that comes in the box with the camera - no difference.
Very occasionally, it'll start recording (like maybe one in about 20 reboots)
Its a pity cause my other car has a blackvue and its been going strong for a good 5 solid years.
I've seen a few posts about people having the same issue, so I'm assuming the cam is dead. But it boots up, never says "recording, 2 channels started" then a couple of second later I hear the boot sound again (repeat forever).
I'm using the viofo hardwire kit for this particular cam and its about 8 months old.
What i've tried so far:
1) eject the card (boots and says "please insert memory card, please insert", yes it stops mid sentence, but doesn't reboot again)
2) reset (both yellow and wifi button which causes a beep, and the reset in the recessed hole), neither works
3) new card - no difference
4) tried the USB power supply that comes in the box with the camera - no difference.
Very occasionally, it'll start recording (like maybe one in about 20 reboots)
Its a pity cause my other car has a blackvue and its been going strong for a good 5 solid years.