Bricked GS98C, Direct USB cant connect... SOLVED

afarkas

New Member
Joined
Nov 19, 2016
Messages
4
Reaction score
0
Country
Slovakia
Hi,
i modified my firmware on my GS98C (same as GS90C) and after successful flashing and the camera shut off it does not starts anymore.
When plugged (wall or PC) only the blue light turns on.
I had try DirectUSB to recover, but it can not connect...
Error says Found 0 AMBA device!
I believe i have drivers installed correctly, but the device does not appear in device manager.
I believe i made my OTG cable correctly...
Any advice how to recover the camera is deeply appreciated.
Thanks in advance
 
Last edited:
There happened something i cant explain. As i had read on some forum that disconnect the battery for a while can help, i completely disassembled the camera and un-soldered the battery, but even this did not helped. After re-assembling and trying again i gave up. Some hours later i made an other try and then, by pressing the left arrow when connecting the camera suddenly appeared in device manager and could connect with DirectUSB...
After this the well known recovery by downloading the .elf file solved everything.
I bricked the camera when attempted to remove the "0 km/h" tag in video when GPS is switched off by editing PRl.a7s file with text editor...
 
Back
Top