liet
New Member
Hi Everyone,
I have a problem with the ITB-100HD that I have recently purchased.
Since I was unable to find any reference to my problem in the existing threads, I have decided to open a new one.
Here goes:
Normaly, when I start the car and the camera receives power, it starts recording after playing three tones (low-mid-high).
It didn't cause me any issues for a few days, but unfortunately it started misbehaving.
The scenario described can happen during the power on, or during normal camera operation.
an example:
The card starts; the camera receives power and approx. 30 sec. later starts recording.
After a while (no fixed time, it varies and sometimes doesn't happen at all) the camera starts emitting a four tone sound sequence (super-short super-short short short).
The sequences lasts a second, then a second break and it starts again.
After a while, the sequence changes to three tones (long short short). It does that for a minute and reboots.
Then we here the three tones (normal startup) and the whole thing start all over again (four tones for ~10 seconds, then three tones for a minute and a reboot).
Unplugging the camera from the power socket doesn't seem to do much as once the camera powers back on, the whole thing starts again.
The weird thing is, that it usually stops on it's own and resumes normal operation (after a number of reboots).
The FW installed is: 2.0
I am using the SD card that was included with the camera
I did not find any reference to the sound codes I am getting in the manual
When I will have some spare time I will upload the videos showing what's happening to youtube
I would appreciate your feedback on the matter.
Kind Regards,
liet
I have a problem with the ITB-100HD that I have recently purchased.
Since I was unable to find any reference to my problem in the existing threads, I have decided to open a new one.
Here goes:
Normaly, when I start the car and the camera receives power, it starts recording after playing three tones (low-mid-high).
It didn't cause me any issues for a few days, but unfortunately it started misbehaving.
The scenario described can happen during the power on, or during normal camera operation.
an example:
The card starts; the camera receives power and approx. 30 sec. later starts recording.
After a while (no fixed time, it varies and sometimes doesn't happen at all) the camera starts emitting a four tone sound sequence (super-short super-short short short).
The sequences lasts a second, then a second break and it starts again.
After a while, the sequence changes to three tones (long short short). It does that for a minute and reboots.
Then we here the three tones (normal startup) and the whole thing start all over again (four tones for ~10 seconds, then three tones for a minute and a reboot).
Unplugging the camera from the power socket doesn't seem to do much as once the camera powers back on, the whole thing starts again.
The weird thing is, that it usually stops on it's own and resumes normal operation (after a number of reboots).
The FW installed is: 2.0
I am using the SD card that was included with the camera
I did not find any reference to the sound codes I am getting in the manual
When I will have some spare time I will upload the videos showing what's happening to youtube
I would appreciate your feedback on the matter.
Kind Regards,
liet