Martanez
New Member
Hi guys.
I have Kenwood dashcam A601w. No damage no crack. Before working normally but once morning no power. Blue Lamp on plug working, voltage 5V existing checked by mulrimeter. When cable power on try to push power key respond with blue light for 1 sec.
On official kenwood site found instruction to down load zip with lastest firmware, decompress in flash card for update firmware.
But in instruction explains to make it on camera which is in "power on" mode. But how enter in flash mode when camera is "power off" and not respond to power key?
I try to find service manual but not found in network.
I have experience repair and reflashing mobile-phones 2005-2015 years.
Any solution how flash dash cam no power?
I have Kenwood dashcam A601w. No damage no crack. Before working normally but once morning no power. Blue Lamp on plug working, voltage 5V existing checked by mulrimeter. When cable power on try to push power key respond with blue light for 1 sec.
On official kenwood site found instruction to down load zip with lastest firmware, decompress in flash card for update firmware.
But in instruction explains to make it on camera which is in "power on" mode. But how enter in flash mode when camera is "power off" and not respond to power key?
I try to find service manual but not found in network.
I have experience repair and reflashing mobile-phones 2005-2015 years.
Any solution how flash dash cam no power?