sjrnrs
New Member
Blackvue DR970X Plus, Non-LTE version installed on a Mazda 3 2024 model
Had the car since Jan 2024, installed Dashcam around early Feb 2024. Dashcam and parking mode was working fine from installation until today. Use to be able to get over 24+ hrs of parking mode before a low voltage cut-off occurred.
Today I have driven to work and as soon as the vehicle was powered off it shut down due to low voltage cut off. After work, I drove it home (about 20min drive) and as soon as I turn off the car, once again, low voltage cut off and the camera powers off.
I have attempted to adjust the voltage cut off from 12.0V to 11.9V and that seems to delay the cut off but I am concerned about keeping the cut off at 11.9V.
Any ideas for why this is the case? Could it be related to wiring? Should I just drive around for longer, allow the battery to charge up and see if it continues?
Had the car since Jan 2024, installed Dashcam around early Feb 2024. Dashcam and parking mode was working fine from installation until today. Use to be able to get over 24+ hrs of parking mode before a low voltage cut-off occurred.
Today I have driven to work and as soon as the vehicle was powered off it shut down due to low voltage cut off. After work, I drove it home (about 20min drive) and as soon as I turn off the car, once again, low voltage cut off and the camera powers off.
I have attempted to adjust the voltage cut off from 12.0V to 11.9V and that seems to delay the cut off but I am concerned about keeping the cut off at 11.9V.
Any ideas for why this is the case? Could it be related to wiring? Should I just drive around for longer, allow the battery to charge up and see if it continues?