Hi all, I've had my new Viofo A119s in my car for a few weeks now, upgraded to MOD-6Vj firmware, all working fine. My car, a 2018 Ford Focus accessory sockets stay on for about 70 minutes after the ignition is switched off and I have the cam powered from these at present. As an option to hardwiring is it possible to enable motion detection and expect it to record normally when I drive the car but (hopefully) stop recording when it decides there's no motion? I understand that motion detection can result in non stop recording but as my car switches off after 70 minutes this would be no worse than the situation now. I do intend to hard wire it but I've had a quick look at the fuses and there's a few different types in there, micro, 3 bladed ones etc so haven't had a good prod around yet to see what I can achieve. Thanks.