My E360 arrived

I wonder if the power down and letting it sit (as a reboot loop solution) is similar to pressing the reset button on the E360? I haven’t had the reboot issue, but also did not update the firmware.
 
I've not done any testing over the last week or so, but I have now returned the E360 to the car and formatted the card in camera after resetting the unit.

Connected just the front via the cigarette lighter socket (with the Vantrue cable) I watched the unit for 2 minutes and it didn't reboot.

Tomorrow I will drive the short distance to and from work and check to see if it doesn't reboot like previously.
 
Last edited:
Eventually went on a pretty long drive up into the hills.

Front unit only.

Connected via 12v power supply after resetting the unit and now the re-booting cycle has gone. Camera ran for the whole journey.


Framerate 30.00 frames/secFrame
Width 5184Frame
Height 1944
Date rate 28650kbps
Total bitrate 28715kbps
File size 901MB for 4m20sec video length.


Paul.
 
I wonder if the power down and letting it sit (as a reboot loop solution) is similar to pressing the reset button on the E360? I haven’t had the reboot issue, but also did not update the firmware.
I wanted to ask the same question. Yes, to me it seems like disconnecting it from the power supply. I thought it would also return the camera to its factory settings, but no, that has to be done from the configuration menu.
-------------
Quería hacer la misma pregunta. Si, a mí me parece que es como desconectarla de la alimentación eléctrica. Yo creía que además volvería la cámara a sus valores de fábrica pero no, eso se tiene que hacer desde el menú de configuración.
 
Back
Top