Couple weeks ago I hardwired with 3 wire setup my cam. Parking mode settings were set to 3fps time-lapse.
Recently somebody scratched my car (while I had lunch at the restaurant) on the driver side(looks like 7inch key scratch) and cam didn't capture this - therefore I'm considering purchasing another one and using the rear cams as side monitoring. I'm thinking about installing both of them on the drivers mirror and make them 'look' to the sides.
This incident made extra mad as recently I purchased and installed this cam and still I didn't capture it!
I was going through the cam footage and found that around the time when it happen cam switched from parking mode to standard recording mode, why did that happen? Possible detected the impact? How much of the video capture am I loosing during switch like that?
I think big downside of the time-lapse recording is that you don't have the sound recorded which in my case would be useful since the camera was recording front and rear and not the sides... I could possibly hear this asshole doing it and would be at least easier to correlate people with incident who where around that time near my car.
What are y'all suggestion for the best parking mode settings?
Could you also tell me how the G sensor behave and how to take the best advantage of it? When the impact detected is communicated somehow on the device itself?
Is there a fast way to find video footage that contains events like that? I'm using 256gb microSD card and it takes lots of time to go through the footage. What I think would be useful is if the event like that happened then the files should be named differently so you could ASAP start dealing with the vandal.
Are there any other features of this A129 duo that could be helpful with catching incidents like that? Not sure if my current config is best possible...
Thanks
Recently somebody scratched my car (while I had lunch at the restaurant) on the driver side(looks like 7inch key scratch) and cam didn't capture this - therefore I'm considering purchasing another one and using the rear cams as side monitoring. I'm thinking about installing both of them on the drivers mirror and make them 'look' to the sides.
This incident made extra mad as recently I purchased and installed this cam and still I didn't capture it!
I was going through the cam footage and found that around the time when it happen cam switched from parking mode to standard recording mode, why did that happen? Possible detected the impact? How much of the video capture am I loosing during switch like that?
I think big downside of the time-lapse recording is that you don't have the sound recorded which in my case would be useful since the camera was recording front and rear and not the sides... I could possibly hear this asshole doing it and would be at least easier to correlate people with incident who where around that time near my car.
What are y'all suggestion for the best parking mode settings?
Could you also tell me how the G sensor behave and how to take the best advantage of it? When the impact detected is communicated somehow on the device itself?
Is there a fast way to find video footage that contains events like that? I'm using 256gb microSD card and it takes lots of time to go through the footage. What I think would be useful is if the event like that happened then the files should be named differently so you could ASAP start dealing with the vandal.
Are there any other features of this A129 duo that could be helpful with catching incidents like that? Not sure if my current config is best possible...
Thanks