I bought two A119S off ebay. One has been working perfectly for the last 9mths. The other was replaced after 6mths due to focus issues when it heated up.
The replacement was working great for a couple of weeks until it just stopped. When I powered it on it was just stuck on the viofo logo. I tried powering it on several times but would stay on viofo logo.
I thought I'll flash it with latest firmware V2. 4 as it came with V1. 7 just to see if that would fix it. Now it's in a constant loop cycle and never gets past the viofo logo.
I tried flashing other variants of the firmware but all return the same fault.
I think it could be dead.
Here is what happens when I boot it up now
https://www.dropbox.com/s/9uso3y44fjvg8ff/A119s rebooting .mp4?dl=0
Any suggestions welcomed.
Sent from my SM-N950F using Tapatalk
The replacement was working great for a couple of weeks until it just stopped. When I powered it on it was just stuck on the viofo logo. I tried powering it on several times but would stay on viofo logo.
I thought I'll flash it with latest firmware V2. 4 as it came with V1. 7 just to see if that would fix it. Now it's in a constant loop cycle and never gets past the viofo logo.
I tried flashing other variants of the firmware but all return the same fault.
I think it could be dead.
Here is what happens when I boot it up now
https://www.dropbox.com/s/9uso3y44fjvg8ff/A119s rebooting .mp4?dl=0
Any suggestions welcomed.
Sent from my SM-N950F using Tapatalk