Setting Clarifications/Recommendations when Hard-Wired to Permanent Live

[povgride742]

Hello,

I'm going to be hard-wiring my 522GW to a permanent live supply. I will have 'Parking Mode' set to on.

1. The 'G Sensor' setting is independent of 'Parking Mode', so even if 'G Sensor' is set to off, the camera would still turn off if the car was bumped, correct?
2. 'Auto-Off' only applies when the camera loses power, which wouldn't apply here as it will be hard-wired to a permanent live, but is there a recommendation for what to set 'Auto-Off' to in this scenario, or does it not matter?
3. Also, anyone know where to get replacement 3M sticky pads for the mounts?

Thank you,
Brett

 

[Nextbase Support]

Hello Brett,

Thank you for your questions. Please see the answers below:
1. That is correct.
2. I'd recommend Auto Power Off set to 'Off'. I'd recommend Parking Mode set to 'On'.
3. All spare parts for Nextbase Dashcams can be purchased here: https://nextbaseparts.co.uk/

Please let me know if you have any further questions.

Kind regards,
Millie
Nextbase Technical Support

 

[povgride742]

Hello Brett,

Thank you for your questions. Please see the answers below:
1. That is correct.
2. I'd recommend Auto Power Off set to 'Off'. I'd recommend Parking Mode set to 'On'.
3. All spare parts for Nextbase Dashcams can be purchased here: https://nextbaseparts.co.uk/

Please let me know if you have any further questions.

Kind regards,
Millie
Nextbase Technical Support

Thank you, Millie.