Teething Problems

[3canctheayr]

I pressed the power button ( the large round one on the side)for about 10 seconds.
The camera went off, then flashed on again a few seconds later.
It now allows me into the preview menu, but that's about it.

 

[3canctheayr]

Ok- got the up button working and can access the menu now. I'm not sure what happened that it works now...........???

However, it now has a message on the screen that says the card is full.

What is the proper setting for loop mode? It's currently set to off.

 

[jokiin]

However, it now has a message on the screen that says the card is full.

What is the proper setting for loop mode? It's currently set to off.

loop off it will just fill the card and stop recording, will even give you a message to say the card is full 😉