Undervoltage problems with mini2

[Nedla]

I have the problem with my new car that when starting the voltage to the dashcam is around 11.8 volts.
This is causing problems with my VIOFO 119 mini2. Is this normal, i.e. is it very sensitive when there are undervoltages? Even if the voltage increases after a few seconds, the error remains.

Feed

 

[Nigel]

If you are using the lighter socket charger then 11.8 volts should be fine.
But it is common for the lighter sockets to turn off while starting the engine.
If you are using the hardwire kit, then that might be the cut-off voltage to save the battery.

The A119 does have a startup delay setting, so you can tell it to wait a few seconds before starting, which might solve your problem...

The dashcam itself runs on 5 volts, so it is not sensitive at all to whatever voltage is going into the 12 volt voltage converter, only to the converter turning off for some reason.

 

[VIOFO-Support]

I have the problem with my new car that when starting the voltage to the dashcam is around 11.8 volts.
This is causing problems with my VIOFO 119 mini2. Is this normal, i.e. is it very sensitive when there are undervoltages? Even if the voltage increases after a few seconds, the error remains.

View attachment 76105








Feed

You may set the boot delay to 10S in the settings to have a try.