I’ve been running my FineVu CR-500HD for about 8 months now, and recently I’ve noticed two specific problems:
1. The camera often does not go into parking mode, and instead continues to record in normal mode for hours on end, despite my car being parked and turned off. When I go to review the videos, sometimes the camera will have properly switched itself into parking/motion detection mode, but often I’ll see hours on end of normal mode recordings of my vehicle parked in a garage. It is set to automatically go into parking mode- I have never had to manually switch it on.
2. For some reason, the camera also misses large periods of time, i.e. no recordings for hours at a time. Sometimes it is missing an hour or so, sometimes it is missing multiple hours with no recorded footage. Occasionally, when I watch the next available footage (i.e. if there is a gap between 200pm and 500pm, when I load the 500pm clip), it will start with the camera beeping, as though it just started up; has it crashed in the meantime? However, sometimes there is no beeping sound, simply a gap of missing footage.
My vehicle spends most of its time parked in an underground garage so temperature is a non-issue. The voltage readings in the videos show plenty of charge with no significant fluctuations, so it is not a battery cutoff problem either. I did swap out a SanDisk 16GB for a SanDisk 32GB microSD card a few months ago; is this possibly a problem for the camera? Any advice on troubleshooting would be greatly appreciated- I want to avoid missing footage, either b/c the camera wasn’t in parking/motion detection mode, or b/c the camera wasn’t recording at all, in the event of another parking lot hit and run. Thanks in advance!
1. The camera often does not go into parking mode, and instead continues to record in normal mode for hours on end, despite my car being parked and turned off. When I go to review the videos, sometimes the camera will have properly switched itself into parking/motion detection mode, but often I’ll see hours on end of normal mode recordings of my vehicle parked in a garage. It is set to automatically go into parking mode- I have never had to manually switch it on.
2. For some reason, the camera also misses large periods of time, i.e. no recordings for hours at a time. Sometimes it is missing an hour or so, sometimes it is missing multiple hours with no recorded footage. Occasionally, when I watch the next available footage (i.e. if there is a gap between 200pm and 500pm, when I load the 500pm clip), it will start with the camera beeping, as though it just started up; has it crashed in the meantime? However, sometimes there is no beeping sound, simply a gap of missing footage.
My vehicle spends most of its time parked in an underground garage so temperature is a non-issue. The voltage readings in the videos show plenty of charge with no significant fluctuations, so it is not a battery cutoff problem either. I did swap out a SanDisk 16GB for a SanDisk 32GB microSD card a few months ago; is this possibly a problem for the camera? Any advice on troubleshooting would be greatly appreciated- I want to avoid missing footage, either b/c the camera wasn’t in parking/motion detection mode, or b/c the camera wasn’t recording at all, in the event of another parking lot hit and run. Thanks in advance!