kps
Member
- Joined
- Feb 18, 2013
- Messages
- 42
- Reaction score
- 21
- Location
- Waterloo, Ontario
- Country
- Canada
- Dash Cam
- F500LHD (front), Innovv C2 (rear)
I recently received my Innovv C2 (ordered direct from Innovv) and installed it in my rear window just over a week ago. After a week I looked at the results, and it has only been recording about half the time.
This past weekend I switched to a bigger charger (the one I am using now is a tablet charger marked 2100mA), and added an LC filter to make sure the power is clean, but this has not made any difference.
When I test it, about half the time, the camera starts recording as it should when the power is turned on. About half the time, the LED comes on red and stays solid red. In this case, the camera does not turn off when the power is turned off, and the Shutter and Mode buttons do nothing, but holding down the power button turns the camera off.
My c1config.bin file looks like this:
RockThinking, if you are following this forum, I would be happy to collect debug logs or whatever else might help troubleshoot this.
This past weekend I switched to a bigger charger (the one I am using now is a tablet charger marked 2100mA), and added an LC filter to make sure the power is clean, but this has not made any difference.
When I test it, about half the time, the camera starts recording as it should when the power is turned on. About half the time, the LED comes on red and stays solid red. In this case, the camera does not turn off when the power is turned off, and the Shutter and Mode buttons do nothing, but holding down the power button turns the camera off.
My c1config.bin file looks like this:
Code:
datetime=2014:05:25 23:37:05
videostamp=VA3TCS
datestamp=on
recordingindicator=on
poweronrecord=on
videosound=on
motiondetect=off
hz=60
continueshot=1
photosize=3m
gsensor=normal
autopoweroff=30s
saturation=normal
wb=normal
moviesize=1080p
selftime=off
ev=0
videocliplength=5min
tvmode=ntsc
RockThinking, if you are following this forum, I would be happy to collect debug logs or whatever else might help troubleshoot this.
Last edited by a moderator: