Master Monki
New Member
- Joined
- Jun 30, 2014
- Messages
- 4
- Reaction score
- 0
- Country
- United States
Hi all... this is my first post and hopefully it's not too crazy.
Has anyone built their own dashcam from parts? I'm not talking about just switching out the sensor of an existing dashcam or modifying the mount. I'm talking about:
A) Assembling individual components that are already compatible (Novatek NT96650, Aptina AR 0330, capacitor, circuit board, SD Card reader)
B) Getting the firmware to work
C) 3D printing a casing / shell
Excuse my ignorance if this is a silly question... but I'm very curious. Thanks.
Has anyone built their own dashcam from parts? I'm not talking about just switching out the sensor of an existing dashcam or modifying the mount. I'm talking about:
A) Assembling individual components that are already compatible (Novatek NT96650, Aptina AR 0330, capacitor, circuit board, SD Card reader)
B) Getting the firmware to work
C) 3D printing a casing / shell
Excuse my ignorance if this is a silly question... but I'm very curious. Thanks.