Hitec
New Member
I received my LK-7900 a few days ago installed it and it worked fine for a few days. It is connected to a
constant voltage source and the UPS battery and so it gets voltage with the car turned off or turned on while
voltage drain is protected by the UPS.
Today all I get once it boots is LOPO then 7.15
I checked my input voltage and it is 14.2 volts!! I plugged the lk-7900 directly to the power source
without using the UPS battery and the LK-7900 still booted and gave me a LOPO and then a 7.15.
I think I may need to send this in for a replacement unless someone has a suggestions.
I am getting ready to reload the firmware to see if that corrects the problem.
Ok, I set the UPS battery cut-off to 11.9 volts.
I've already loaded the new firmware.
---LUKAS VIEWER---
I configured the highest video (11)
Speed-time-date set
MPH set
-5:00 (summer time) set
70 - 20 - 10 for the SD card storage
Lucas_Flash.bin setup for driving information
Any suggestions why I keep getting LOPO and then 7.15 volts?????????????/
Thanks
Everything was working fine for the first few days, but now, every time I boot the camera
constant voltage source and the UPS battery and so it gets voltage with the car turned off or turned on while
voltage drain is protected by the UPS.
Today all I get once it boots is LOPO then 7.15
I checked my input voltage and it is 14.2 volts!! I plugged the lk-7900 directly to the power source
without using the UPS battery and the LK-7900 still booted and gave me a LOPO and then a 7.15.
I think I may need to send this in for a replacement unless someone has a suggestions.
I am getting ready to reload the firmware to see if that corrects the problem.
Ok, I set the UPS battery cut-off to 11.9 volts.
I've already loaded the new firmware.
---LUKAS VIEWER---
I configured the highest video (11)
Speed-time-date set
MPH set
-5:00 (summer time) set
70 - 20 - 10 for the SD card storage
Lucas_Flash.bin setup for driving information
Any suggestions why I keep getting LOPO and then 7.15 volts?????????????/
Thanks
Everything was working fine for the first few days, but now, every time I boot the camera