HonestReview
Well-Known Member
- Joined
- Feb 9, 2019
- Messages
- 3,557
- Reaction score
- 790
- Country
- Sweden
I will update soon or later.
But if there is anything wrong with your cables, me doing testing on my cables (either Viofo's ones or my own) won't help you by any way.
But this is still wrong, you should get "3Ch started" right away.
If you are not aware of anything done differently back then I think the only difference is that one of the wires got moved a bit and the contact is better (for now) But thanks to you now we know they probably (I assume) changed something to be more tolerant to "bad" connection.
1st test I didn't reset Settings but it was stuck in a 2 channel boot loop. I did try removing cords and couldn't get it to see 3 channel. 2nd attempt (video posted) it worked immediately but first boots to 2 channel, before boot looping to 3. Then stays in 3 channel.
So the boot loop only happens once after flashing, then stays in 3 channel. UNLESS you remove power cable and other cords (where it loses power completely and connectivity). Then it'll do the 2 channel boot loop to 3 channel.
My guess first time didn't flash properly...But why it does the 2 channel to 3 channel bootloop I don't know.
On firmware Version 1.2, this is NOT an issue at all. Again, I don't know why. But seeing it works fine on 1.2, it leads me to believe cables are not at fault.
I'm a very thorough tester though.....And am pretty good at finding these issues.
Last edited: