Skeezix
Member
- Joined
- Jun 4, 2017
- Messages
- 97
- Reaction score
- 15
- Country
- United States
- Dash Cam
- Viofo A119
I followed the instructions exactly on updating the firmware in my A119 that are on VIOFI's website. Everything went okay, including the format on the computer.
Then I put the A119 back in the car, turned on the ignition and went ahead to set all of the parameters. I couldn't figure out how to get out of the parameter setting mode, so I turned the ignition off.
After about 15 seconds, I turned the ignition back on and viewed the parameters. The date still read 2018-09-01 and the other parameters that I set were the factory defaults too.
How do I get out of the parameter setting mode and return to normal operation?
Then I put the A119 back in the car, turned on the ignition and went ahead to set all of the parameters. I couldn't figure out how to get out of the parameter setting mode, so I turned the ignition off.
After about 15 seconds, I turned the ignition back on and viewed the parameters. The date still read 2018-09-01 and the other parameters that I set were the factory defaults too.
How do I get out of the parameter setting mode and return to normal operation?