Windscreen/rear dash cam mount fixing.

[Dashmellow]

Thanks for all the help. Bought these:
SPYDER - 3M 5952 VHB Pads: 25mm x 50mm, Pack of 10, Black, Heavy-Duty, Extra Strong & Waterproof Double-Sided - UV Resistant, for Glass/Metal/Plastic Bonding, Automotive, DIY, Comes with IPA Wipe

Looks good! It says they are unavailable in your link. Hope you were able to get what you need.

 

[Agie]

When properly applied the stuff works very well. Most tape failures involve some sort of application or prep problem, a contaminate on the glass or moisture. As I mentioned earlier, according to 3M glass is one of the more challenging surfaces for this product and they recommend a chemical adhesion promoter which practically no dash cam owner uses or knows about. Plus the stuff isn't cheap.

That's it, no need. Just clean your windscreen a bit and push on it for a minute and you're golden for years

 

[Dashmellow]

That's it, no need. Just clean your windscreen a bit and push on it for a minute and you're golden for years

Hopefully!

 

[Ralph2]

I found that the curvature of the windshield prevents 100% contact with the "flat" section of the camera mount. My solution was to make an intermediate plate out of a piece of black PVC plastic, same size but shaped on one side to suit the curvature of the windshield. Easy to check out the contact your current mount has by looking at it from the outside, chances are there will be voids/air bubbles.