Member
- Joined
- Feb 12, 2014
- Messages
- 157
- Reaction score
- 14
- Country
- Canada
In 3.9:
1. Device doesn't record or keep all motion despite enough memory.
Despite having a priority given to motion sensor recording setting at 95 % (for testing purposes) on a 32 GB card, the device randomly decided to wipeout the contents of the card rather than just overwriting the oldest. I noticed this a few times because I would get maybe 1/2 to 3/4 of day recording when parked at work or over the weekend idle.
I took the memory card back to my PC and examined it, there are not bad sectors and the card had a lot of memory left on it. Device voltage was lowered as well just in case. However, issue seems to still occur.
2. Voltage reading seemingly is not accurate. Device says the car has 12.1 volts but in reality, it is more like 13. When driving, the voltage is much higher and it peaks at 13.9 volts even when highway driving and in reality is much higher as well.
3. Adjusting the memory allocation slider freezes (new for firmware 3.9) occasionally. I typically have to adjust the allocation via Lukas Viewer.
4. Motion detection is activated by the rain.
The above are just a few of the bugs I came across or can think of right now. Hopefully, others will share more.
1. Device doesn't record or keep all motion despite enough memory.
Despite having a priority given to motion sensor recording setting at 95 % (for testing purposes) on a 32 GB card, the device randomly decided to wipeout the contents of the card rather than just overwriting the oldest. I noticed this a few times because I would get maybe 1/2 to 3/4 of day recording when parked at work or over the weekend idle.
I took the memory card back to my PC and examined it, there are not bad sectors and the card had a lot of memory left on it. Device voltage was lowered as well just in case. However, issue seems to still occur.
2. Voltage reading seemingly is not accurate. Device says the car has 12.1 volts but in reality, it is more like 13. When driving, the voltage is much higher and it peaks at 13.9 volts even when highway driving and in reality is much higher as well.
3. Adjusting the memory allocation slider freezes (new for firmware 3.9) occasionally. I typically have to adjust the allocation via Lukas Viewer.
4. Motion detection is activated by the rain.
The above are just a few of the bugs I came across or can think of right now. Hopefully, others will share more.