hardwire

I have seen more than one posting in DCT (can't find them just now) where they stated, or at least implied, that a certain hard-wiring kit would work with certain dash cam models and actually listed some dash cam models that the particular kit in question was compatible with. I have also seen...

If I have my dash cam hardwired to the fusebox and connected via a Cellink, T-Power Plus or some other similar secondary battery UPS, should I still buy a Battery Discharge Prevention device, such as the Lukas LK-290, Power Magic Pro, or ("the Mercedes of BDPs") the Vico-Power Plus? I am not...

I'm planning to hardwire my dashcam, using add-a-circuit. My original thought was to use my accessory power fuse, which only is powered when the car is turned on. This way the dash camera will turn on automatically when I turned on the car. However, I'm wondering if there is a way to have the...

Hi guys I'm new here but used the forum before to find answers I've hardwired be g1w-cb capacitor dash cam to my fuse box in the cigarette lighter fuse (I have tried in other fuses and they either do the same thing or the camera stays on when the ignition is off which I don't want ) and the...

I thought a new thread would be helpful to generate some more discussion on this topic. I've done a search but can't find much. I have fairly basic electronics knowledge so if you can contribute on this subject then it would also help others who may be asking the same question. The question is...

Hi, In May 2015 I bought two Mini 0806 dashcams. For various reasons, these were never installed until a few days ago, when I got one installed in the fiancee's car. However, it doesn't work. On startup, it makes the dingadinga sounds and displays the car startup image, then immediately...

I've had a G1W-B for a while and it was never hard-wired. I am going to hardwire it. I have two choices (and I already have parts to do either): 1) Connect a cigarette female adapter to an Add-a-Circuit and plug the cam into the adapter using the cam's male cigarette adapter (which contains a 2...

First all the wires: Remove panels and put wire: Make hole for switch*: Ground wire: