After getting the solid green light when my dashcam was powered direct from the car's USB socket, I decided to take it out and run some tests.
Attached to one of my powerbanks the JooVuu X had no problem on 30 continuous power cycles, with no errors. i.e.
One power cycle
1. Connect USB cable to dashcam from powerbank
2. Note green, then continuously red, blinking LED
3. Remove USB cable to dashcam from powerbank
4. Note green, then the "power off" red, blinking LED, then all LEDs off.
So I've decided to run, for now, my dashcam in car off a powerbank (see previous posts on setup). The powerbank acts as a UPS, a parking battery and a current regulator. The powerbank is charged either in car using the centre armrest USB socket or brought indoors for a full cast charge.
I'm interested in any other stability tips (e.g. firmware, config options, SD card formatting, etc)
Sent from my G3112 using Tapatalk
Attached to one of my powerbanks the JooVuu X had no problem on 30 continuous power cycles, with no errors. i.e.
One power cycle
1. Connect USB cable to dashcam from powerbank
2. Note green, then continuously red, blinking LED
3. Remove USB cable to dashcam from powerbank
4. Note green, then the "power off" red, blinking LED, then all LEDs off.
So I've decided to run, for now, my dashcam in car off a powerbank (see previous posts on setup). The powerbank acts as a UPS, a parking battery and a current regulator. The powerbank is charged either in car using the centre armrest USB socket or brought indoors for a full cast charge.
I'm interested in any other stability tips (e.g. firmware, config options, SD card formatting, etc)
Sent from my G3112 using Tapatalk