I want to install mini0906 in Subaru Outback 2015. In the internet I found a lot of information regarding safe cable routing in A pillar but I haven't found too much about rear cable routing in headliner. I was wandering if pushing cable inside will inhibit side curtain airbag to deploy (Somebody recommended to just push cable as far as possible to avoid problems).
I was wandering how would you recommend installing rear cable with car equipped with side curtains? (I would like to avoid removing headliner)
Would you push cable to headliner or it is better to buy longer cable and route it on the floor?
I found in the internet the picture of the Outback without headliner and I would say that pushing cable as far as possible with trim removal tool should be sufficient but it would be great to hear your opinion.
.
I was wandering how would you recommend installing rear cable with car equipped with side curtains? (I would like to avoid removing headliner)
Would you push cable to headliner or it is better to buy longer cable and route it on the floor?
I found in the internet the picture of the Outback without headliner and I would say that pushing cable as far as possible with trim removal tool should be sufficient but it would be great to hear your opinion.
.