VIOFO А119V3 FIRMWARE

gse

gse

Well-Known Member
Joined
Oct 22, 2013
Messages
836
Reaction score
1,001
Country
Russian Federation
Dash Cam
Viofo A329S
Latest A119 V3 Dash Camera firmware is released , version number is V1.01, please check the attachment
support.viofo.com

VIOFO A119 V3 1600P Dash Camera Firmware

Please click below for the A119 V3 firmware page: https://www.viofo.com/pages/firmware?s=A119%20V3%20 You can download the firmware directly here: https://www.viofotech.com/download/firmware/A119V3/FWA119V3.bin
support.viofo.com support.viofo.com

Which changes ?
 
Is WDR still best kept off like in the older A119 models?
 
IHO with the currently available FW Yes. Off is best. There will be others that disagree but there is much room for improvement.
 
Since upgrading to 1.01 my dashcam does not turn on when I start my car.

I have the 3 wire hardwire Kit. If I press the power button it starts of if I remove it from the GPS and mount it back then it starts
 
Try cleaning the contacts. Gently. And check the Hardwire connections.
 
Ok, but the unit is just a week old, and didn’t have this issue until FW 1.01
 
You need to contact Viofo support if after cleaning contacts it is still a problem.
 
fdnyfish said:
Ok, but the unit is just a week old, and didn’t have this issue until FW 1.01
Click to expand...
Suggest troubleshooting by connecting power temporarily to camera side USB port to confirm GPS mount is isn't issue. Its very easy to get EVA foam on contacts which act as insulator.
If no difference using side port always downgrade firmware version to v1.00 confirming v1.01 it is the cause which is very doubtful.
If still no change remove the memory card.
 
fdnyfish said:
Since upgrading to 1.01 my dashcam does not turn on when I start my car. I have the 3 wire hardwire Kit. If I press the power button it starts of if I remove it from the GPS and mount it back then it starts
Click to expand...
Please try to use the original car charger to confirm the issue.
 
Here I performed 2 additional auto power on tests.
1. Hardwire kit directly to camera bypassing the GPS unit
2. OEM Supplied USB adapter and cable directly yo camera bypassing GPS device.
Same results

 
just for the record, I did reset all camera settings and format SD card after upgrading firmware to 1.01
 
I dont hit the power button once the camera is running.

My v2 camera ran fine for months with this same cable

 
Put fw 1.00 back on, it's working fine.

Still hit or miss with FW1.02 for me.
 
Last edited:
You must log in or register to reply here.
Back
Top