Hi all,
After being installed for about 4 months I have been experiencing the same issues as others have reported in this thread - microsd card is being wiped and the unit reports I need to format my card. When I format the card from the unit, it will then tell me to insert a microsd card. When inserting the card into a windows machine it works without issue and windows, minitool partition wizard and hwtest all report the card as being ok. Most recently I formatted the card to FAT32 via minitool partition wizard and the issue reappeared after a day or so not sure on the block size, I'll pay more attention to that after the next format).
Card is a 128gb sandisk ultra card.
Motion detection is off.
G-sensor is Low
Quality is medium
Cycle time is 5 min
Unit is hardwired via a Power Magic Pro unit, which is set to always record until the battery hits 12.4 or 12.2v (don't remember exactly, but it is the highest setting)
Unit is the V2 model.
I will try reformatting and specifying the block size mentioned in this thread, but curious if there are any other solutions? Maybe a firmware upgrade or something?
Thanks