CiderCid
New Member
A couple months ago, I installed a Thinkware F800 Pro only to discover it will not record in parking mode.
After some research, I learnt that the Dashcam needed to be connected directly to a live source. This isn't possible with my car without drilling through the metal bulkhead and running a feed direct from the battery, so plumped for a Cellink Neo 6 to feed the cam.
Now I need to be able to connect the dashcam to the Cellink.
There are spliced leads available for around £50, but being frugal, object to paying that much for what in effect is just a Molex Micro connector on the end of what came supplied with the dash cam.
Does anybody know what wires go to which connector on the Molex male side?
The Thinkware F800 Pro has three wires, Black is Earth/Ground, Red to ACC and Yellow to constant Live (Battery).
Any help would be much appreciated.
CiderCid
After some research, I learnt that the Dashcam needed to be connected directly to a live source. This isn't possible with my car without drilling through the metal bulkhead and running a feed direct from the battery, so plumped for a Cellink Neo 6 to feed the cam.
Now I need to be able to connect the dashcam to the Cellink.
There are spliced leads available for around £50, but being frugal, object to paying that much for what in effect is just a Molex Micro connector on the end of what came supplied with the dash cam.
Does anybody know what wires go to which connector on the Molex male side?
The Thinkware F800 Pro has three wires, Black is Earth/Ground, Red to ACC and Yellow to constant Live (Battery).
Any help would be much appreciated.
CiderCid
Last edited: