TNT
Active Member
- Joined
- May 10, 2015
- Messages
- 107
- Reaction score
- 74
- Country
- Slovakia
- Dash Cam
- SG9663DC
I start again with the rear camera. This was not very much different from the Kia.
Pull the first panel off. Nothing hard here, no tools required. Just stick a few fingers between the plastic and the glass and pull.
Same with the side panels.
Now remove a single clip on each side. I used my finger nail to slide under the center push pin then i slide the tool that comes with the DC to slide between the outer ring and my finger nail. It pushes it out very easily.
Two more clips across the center. Then remove the handle. 2 10mm bolts. Pull off the large panel.
The left side contains the washer fluid hose. Do not run the camera wire on the same side.
Pull the first panel off. Nothing hard here, no tools required. Just stick a few fingers between the plastic and the glass and pull.
Same with the side panels.
Now remove a single clip on each side. I used my finger nail to slide under the center push pin then i slide the tool that comes with the DC to slide between the outer ring and my finger nail. It pushes it out very easily.
Two more clips across the center. Then remove the handle. 2 10mm bolts. Pull off the large panel.
The left side contains the washer fluid hose. Do not run the camera wire on the same side.