even the speed limit here in the Nullarbor plains has been reduced to 130 or something hasn't it from open speed recently??
I have been running the camera via a better USB cable and a different power supply (still not the original one that came with the cam) and did run into the grey gaps issue... until today. I was waiting at a railway crossing when the recording was stopped at 1:06 of the current file and continued in a new file 10 seconds later. Imagining the power goes out and returns directly afterwards, would it take the camera those 10s to boot and start recording?
I think I need to switch the boot sound on such that I recognize when the camera switches on. And I really need to use the original power supply before bugging you guys with silly questions.
That's weird! I just noticed that the files recorded after the 10s gap work as usual in datakam and registrator viewer but apparently dashcamviewer has problems processing the GPS info. The map position is not updated, speed is constant across a full file and the route is not shown. The speed overlay in the movie files is working properly.
Dashcam Viewer can have issues sometimes if the GPS signal is not present in the first section of a file, Registrator Viewer analyses the whole file not just the start so deals with that better
Speaking of silly questions, how do you turn off the start-up sound? I haven't found it in the menu and was thinking about that the other day. I'm going to have to take in my truck for service soon and don't want an audible reminder to the service techs that the dash cam turned on.I think I need to switch the boot sound on such that I recognize when the camera switches on. And I really need to use the original power supply before bugging you guys with silly questions.
Speaking of silly questions, how do you turn off the start-up sound? I haven't found it in the menu and was thinking about that the other day. I'm going to have to take in my truck for service soon and don't want an audible reminder to the service techs that the dash cam turned on.
Oh, ok, that's makes sense. I didn't realize it was an all or nothing sound on or off type of deal.Beep Sound includes startup chime.
Nothing to concern yourself about. You're not the first, nor will you be the last, to fall into that black hole....Apologies for bugging you guys throughout the past days and thanks again for your patience.
Guys, I am feeling sheepish right now I am pretty sure, @jokiin was spot on with his question regarding motion detection very early in this thread. I switched to the original power supply yesterday and hid the cable today. While sitting in the car I noticed that the blinking red LED was turning to a constant glow. The screen showed the animated recording icon but the time of the video was not advancing. Went back to the users manual and read that bit about motion detectionagainfor the first time: "low light or mostly static scenes". The grey gaps appeared when driving at night and while waiting at a railroad crossing
I haven't tested with motion detection switched off yet but it really seems this issue was an obvious case of RTFM. Apologies for bugging you guys throughout the past days and thanks again for your patience.
Thread starter | Similar threads | Forum | Replies | Date |
---|---|---|---|---|
P | How to remove write protection to reformat SD card in SG9665GC? | SG9665GC | 7 | |
J | SG9665GCV3, power light comes on but no boot screen | SG9665GC | 4 | |
P | SG9665GC v1 and v2 Memory Cards | SG9665GC | 4 | |
A | Street Guardian SG9665GC V2 flashes power and mic light then turns off | SG9665GC | 5 | |
SG9665GC V2 Finally dead... | SG9665GC | 0 |